Toro MB-1600 Operator's Manual page 14

4. Release the parking brake lever; refer to
Brake Lever (page
5. To move the machine forward, squeeze the
speed-control-lever on the right handle bar.
To move the machine rearward, squeeze the
speed-control lever on the left handle bar; refer
to Forward-Speed-Control Lever (page 8)
Reverse-Speed-Control Lever (page
Note:
The more you squeeze the handle, the
faster the machine travels.
6. When you release the speed control handle, the
machine stops.
Note:
If the machine does not stop when the
speed control is released, have the machine
inspected by an Authorized Service Dealer.
7. Use your foot to press the brake pedal; refer to
Brake Pedal (page
8. Engage the parking brake lever by pulling up on
the parking brake lever; refer to
Lever (page 8).
9. Shut off the engine; refer to
Engine (page 13).
Parking
8).
8).
8).
Parking Brake
Shutting Off the
Operating the Hopper
Know the load capacities of your machine and never
exceed them. The machine is normally operated on
uneven, unpaved, bumpy, and/or inclined surfaces.
Adjust your load accordingly.
1. Position the machine in the area where you
and
intend to dump the load.
2. Dump the hopper by pushing forward the dump
handle or pressing down on the forward part of
the dump pedal
1. Dump handle
2. Dump pedal
3. Move the hopper to the upright position by
pulling back the dump handle or pressing down
on the rear part of the dump pedal
14
(Figure 6).
Figure 6
3. Hopper dump position
4. Hopper upright position
(Figure
g025722
6).