Toro MB-1600 Operator's Manual page 25

3. Start the engine and run the machine until the
engine shuts off.
4. Rotate the lever for the engine switch clockwise
to the S position, and allow the engine to
TOP
cool (Figure 23).
5. Remove the spark-plug wire
Figure 24
1. Spark-plug wire
6. Remove the hose clamps and hose from the
barbed fitting at fuel filter
Note:
Drain the fuel from the old fuel filter
dispose of the fuel and filter at an authorized
disposal site.
Figure 25
1. Hose (engine switch)
2. Fuel-filter arrow
7. Align the arrow on the case of the new fuel filter
to correspond with the fuel flow to the engine
(Figure 25).
Note:
Ensure that the hose clamps are
slipped over the hoses attached to the engine
fuel-shutoff valve and the tank-shutoff valve.
8. Insert the barbed fitting of the fuel filter into the
hose from the engine switch
(Figure 24).
g019281
(Figure 25).
g025708
3. Hose clamp
4. Hose (tank-shutoff valve)
(Figure 25).
9. Insert the barbed fitting at the other end of
the fuel filter into the hose attached to the
tank-shutoff valve
10. Align the clamps over the hoses at the barbed
area of the filter, and secure the clamps to the
hoses.
11. Connect the spark-plug wire
12. Open the tank-shutoff valve and turn on the
engine switch, and check for fuel leaks
23).
25
(Figure 25).
(Figure 24).
(Figure