Table of Contents
Advertisement
Gas burning pizza brickoven
8.1.4 Flame control
Pushing + and – buttons for a short time flame levels will cycle on the display in the
following order: L1.0/L2.0/L3.0/L4.0/L5.0/AUt
Ranging from L1.0 to L5.0 the flame height inside the oven will be increasingly higher
AUt mode is described in 8.1.7
5 seconds after the selection, if no other buttons are pushed, the display will be showing
temperature reading again
8.1.5 Checking flame levels
Briefly pressing any button (+, –, SET) once will be displaying the actual flame level
5 seconds after the selection, if no other buttons are pushed, the display will be showing
temperature reading again
8.1.6 Customizing flame levels L1.0 to L5.0
When regulating the flame like specified in chapter 8.1.4, if SET button is pressed within 5
seconds from the selection of numeric flame levels (NOT with AUt mode) you will access
"Flame customization mode". In this mode you will be able to fine tune the height of the
flame associated to any of the 5 levels.
rd
Upon entering "Flame customization mode" 3
digit on the display (default = 0) will start
blinking.
+ and – button will allow to increase the associated flame level modifying the value from 0
to 9. If you change the value, you can record it by pressing SET button to exit selection
immediately, or wait 5 seconds: new value will be saved in any case.
R-001 100518
Page 26 of 33
Advertisement
Table of Contents
