Table of Contents
Advertisement
3. Remove the access cap by using a wrench, turning the access cap anticlockwise.
4. Remove sprint retainer from the cap by pushing against the flat side of the spring
retainer. Look at the spring retainer to locate the "NAT" or "LP" position.
5. Turn over the spring retainer so the "LP" is showing on the bottom.
6. Snap the spring retainer back into the cap.
7. Reinstall the cap onto the regulator.
8. With a nut driver remove the gas nozzle "U" by turning it anticlockwise and lifting out.
Set gas nozzle aside. Fig 7.2
9. Gas nozzles are stamped with a number on the side. The number represents the
size of the orifice in mm
10. Place the replaced nozzle in a plastic bag for future use and keep it with literature
package.
11. Loosen the V screw.
12. Shift the Z sleeve.
13. Adjust the Z sleeve to the distance H corresponding to the new installation (refer to
pag.11 for regulation values) and tighten the V screw.
R-001 100518
Gas burning pizza brickoven
Page 21 of 33
Advertisement
Table of Contents
