Maintenance - Husqvarna 520iLX Operator's Manual

1. Push the SavE button to start the function. The
green LED comes on to show that the function is on.
2. Push the SavE button again to stop the SavE
function.
To change the operation direction of the
trimmer head
It is possible to change the operation direction of the
trimmer head. This can be done at full speed or at stop
position. In the factory, the trimmer head is set to turn
clockwise. The green LED is off when the trimmer head
turns clockwise.
1. Push the operation direction button to make the
trimmer head turn counterclockwise. The green LED
is on when the trimmer head turns counterclockwise.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
WARNING: Remove the battery before you
do maintenance.

Maintenance

Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
20
Note: It is easier to tap out the trimmer line to make it
longer when the trimmer head turns clockwise.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if the product is not used. The green
LED for start/stop indication goes off and the product
stops after 120 seconds.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED is off.
3. Push the release buttons on the battery and pull the
battery out.
Maintenance
The following is a list of the maintenance steps that you
must do on the product. See
for more information.
Maintenance on page 20
Daily Weekly Monthly
X
X
X
X
X
756 - 003 - 24.06.2020