Nice EDSB Instructions And Warnings For Installation And Use page 10

tem reconfirms the previously selected command.
press the button previously pressed at Point 02 to confirm the
chosen command once more.
8.2 - Locking / unlocking the automation
This function allows for sending, through the keypad, the
command for "locking" or for "unlocking" the automation.
I1I
Press the  button: the keypad will signal the "incorrect
I2I
combination" error. Wait 10 seconds: • to lock the automa-
tion = enter "0-0". • to unlock the automation = enter "1-1".
I3I
Within 10 seconds enter any valid combination.
the  button to confirm the action selected at Point 02. If
the procedure was performed correctly, the keypad will emit
3 buzzes and the "L2" LED will indicate the operating status
(see Table 6).
TABLE 5 - Commands that can be associated with
the buttons  or 
"L1" LED signal Command
STEP-BY-STEP (by default
1 flash + pause
paired with the  button)
2 flashes + pause OPEN
3 flashes + pause CLOSE
PARTIAL OPENING (by default
4 flashes + pause
paired with the  button)
5 flashes + pause STOP
6 flashes + pause COURTESY LIGHT
9 – English
I4I Lastly,
8.3 - Erasing the entire memory
I1I
Press and hold button "T": the "L1" LED will remain lit;
wait for it to flash 3 times then release button "T" during the
I2I
third flash.
light pulses followed by 3 buzzes; after this, the LED on the
front will flash 5 times.
"recognition of the devices connected to the control unit", by
consulting the control unit manual.
At the end of this procedure, the device will have to be re-
programmed. Note – at the start of a new programming op-
I4I
Press
eration, the user can once again choose which mode to use
("Easy" o "Professional").
9 - WARNINGS FOR USE OF THE DEVICE
The device operates through numerical combinations that
l
the user must know and enter onto the keypad for sending
commands to the automation.
programmed combinations (and relative commands associ-
ated with them) should only be disclosed to users authorised
to operate the automation.
the command can be transmitted by pressing the command
button ( or ) associated with the relevant combination.
the entered combination is incorrect, the device emits a buzz.
Important! – After the third consecutive entry of the incorrect
combination, the system blocks the device's operation for 60
seconds. Therefore, the user who makes a mistake while en-
tering a combination should suspend the operation and wait
10 seconds before entering the combination again, starting
from the first digit.
At this stage, the "L1" LED will emit a series of
I3I
Lastly, rerun the procedure for the
For security reasons, the
l
After entering the combination,
l
While entering a combination, the user
l
If
l