Battery Use And Replacement - Orbit Research Orbit Reader 20 Plus User Manual

Orbit Reader 20 Plus – User guide
2. Hold the Power button for two seconds.
Option 3: Unplug the device
1. If the unit is plugged in, unplug the power cord.
2. Hold the Power button for at least two seconds.
Option 4: Reset device
1. Press the Reset command (Dot 8 + right-bottom Panning key). Note: On
reset, the unit is unresponsive, and there is no change to the display.
2. Hold the Power button for at least two seconds.
Option 5: Remove the battery
Note: Use this option as a last resort.
1. Call customer service for guidance on safely removing the battery.
2. Leave it out for a few minutes.
3. Reconnect it, then try the options again.
If none of the options work and the device does not come on, contact Customer
Service at techsupport@orbitresearch.com.

26 Battery Use and Replacement

The Orbit Reader 20 Plus includes a rechargeable Lithium-ion battery. It fully
charges in about three hours under optimal conditions. A full battery charge lasts
approximately three days of typical use. You can check Battery status in the
Menu.
When the battery in Orbit Reader 20 Plus gets to 10%, Dot 8 of the 20th cell on
the display starts blinking. This behavior is normal, indicating that the battery is
low.
The battery in Orbit Reader 20 Plus should last several years. Gradually, the
battery begins discharging faster than usual. When the amount of time that the
battery holds charge becomes inconvenient, it is time for a replacement.
To replace the battery, follow these steps:
1. Obtain a replacement battery. Use only the battery designed for Orbit
Reader 20 Plus. Batteries are available from:
o American Printing House for the Blind, Inc.
Orbit Research, Inc.
o
2. Remove the battery door screws.
Orbit Research Confidential and Proprietary Information
Version 1.0
75