Part 5 Maintenance; Part 6 Troubleshooting - Maxwell AutoAnchor 730 Owner's Manual

PART 5 MAINTENANCE

The AutoAnchor does not contain any user servicable parts.
necessary.
magnet and replacing the sensor if necessary. After any sensor repairs or changes to
sensor installation reset the sensor. See page 30.
it with a clean damp cloth. Avoid wiping the display screen with a dry cloth as this could
scratch the screen.

PART 6 TROUBLESHOOTING

troubleshooting. These messages are designed to assist the user. They may be
information messages, for example that the console is locked, or the sensor is tuning.
They may also be diagnostic messages, for example, that the sensor installation is not
compatible or the power supply is wired incorrectly.
information on the following pages.
Please Note: Th
caused by a fault with the AutoAnchor.
TROUBLESHOOTING
MESSAGES
1. Auto mode disabled
Note: Unless the fault is
in the solenoid wiring the
AA730 will operate the
windlass in manual mode
when this message is
displayed.
operate windlass.
The voltage displays on the
status bar.
POSSIBLE CAUSE/ACTION
2. The sensor installation is not compatible with rope and chain
1. If the battery is fully charged, check the wiring for bad
connections.
wrong size there may be voltage drop between the battery and the
38
They are not