Part 2 Installation - Maxwell AutoAnchor 730 Owner's Manual

PART 2 INSTALLATION

2.1 INSTALLATION TO OPERATE A WINDLASS
2.1.1 MAGNET AND SENSOR INSTALLATION
PLEASE READ BEFORE COMMENCING INSTALLATION
Correct magnet and sensor installation is critical for successful AutoAnchor
operation.
The AutoAnchor can be installed on vertical windlasses, drum winches and most
horizontal windlasses. Installation differs depending on the windlass type and on the
rode (all-chain or rope and chain). Please follow the instructions for your windlass
and rode. If it is not possible to comply with these instructions please check with the
AutoAnchor manufacturer or your supplier for other options or if you are not sure how to
proceed.
www.autoanchor.co.nz for contact information.
2.1.2 MAGNET INSTALLATION OVERVIEW
Check before starting.
Magnet Polarity:
the magnet must face the sensor.
Magnet Seal: Insert the magnet into the hole and cover it with a minimum of 1mm of epoxy
Magnet Size and Position:
2.1.3 SENSOR INSTALLATION OVERVIEW
Vertical Windlasses:
Drilling the Deck:
the sensor hole in the deckplate.
4