Table of Contents
Advertisement
FiberPlex FP1004E User Manual
2 • Installation
Figure 10. FP1004E Surface Mount
DIN Rail
Using the TD-DINR, the FP1004E can be mounted to a DIN rail. See the TD-DINR user manual for more
details on configuration options. Mount the FP1004E the TD-DINR in the same manner regardless of the ini-
tial configuration of the mount itself or the height of top hat DIN rail utilized (35 x 7.5 or 35 x 15mm). The
edge mounting solution happens to be shown in
figure 11
on page 23. All fasteners necessary for configuration
and mounting are included with the TD-DINR.
1. Line up key hole on the bottom of the FP1004E with the studs on the mounting bracket and push flat
against the plate.
2. Slide the FP1004E forward until it stops.
3. Tighten the retaining screw until snug.
4. Snap the rail clips on to the DIN Rail.
Power Requirements and Mounting
22
Advertisement
Table of Contents
