FiberPlex FP1004E User Manual
#
Item
1
Link LED (x4)
2
Ethernet Cable
Port (x4)
3
Speed LED (x4)
4
VLAN/Switch
switch
5
Reset switch
6
SFP Slot 6
7
SFP Slot 5
8
PWR (power) LED When lit, indicates that the FP1004E is powered on.
9
FX6 LED
10
FX5 LED
FiberPlex 1004E Front
Table 1. Front panel ports, LEDs, and switches
This LED, for each position, indicates port link status as follows:
•
On—Link is OK
•
Off—No link present
•
Blinking—Data is being received or transmitted
These jacks are unshielded twisted pair (UTP) RJ-45 cable connection
points for Cat 5 capability.
This LED, for each position, indicates port speed status as follows:
•
3 Blinks Repeating—1000M speed
•
2 Blinks Repeating—100M speed
•
1 Blink Repeating—10M speed
When the toggle is set up to VLAN, it puts the FP1004E in VLAN mode.
Each port is set to 100Base-TX and isolated. This feature expects the
FP1004E to be used in pairs. Ethernet port 1 on FP1004E will only con-
nect to port 1 of another FP1004E.
When the toggle is set down to Switch, it puts the FP1004E in standard
switch mode..
The Reset switch toggle must be pressed upwards for one second after
changing the VLAN/Switch switch setting from VLAN to Switch or Switch
to VLAN.
This is a standard MSA-compliant SFP module slot. (See section
ing and Removing SFP Modules"
1000Base-X rates. Do not connect ports 5 and 6 of one unit to SFP
ports 5 and 6 of a second unit because this will cause a switching
loop and the units will not operate properly.
This is a standard MSA-compliant SFP module slot. (See section
ing and Removing SFP Modules"
1000Base-X rates. Do not connect ports 5 and 6 of one unit to SFP
ports 5 and 6 of a second unit because this will cause a switching
loop and the units will not operate properly.
This LED indicates status of SFP slot 6 as follows:
•
ON—Fiber link is OK
•
OFF—Fiber link has failed
•
Blinking—Activity
This LED indicates status of SFP slot 5 as follows:
•
ON—Fiber link is OK
•
OFF—Fiber link has failed
•
Blinking—Activity
1 • General information
Description
on page 24.) This port operates only at
on page 24.) This port operates only at
"Insert-
"Insert-
17