Percussion Play Papilio Bells PPBUTR Installation Instructions

Surface fixed

Advertisement

Installation Instructions
(1.1)
Surface Fixed
Papilio Bells
Page 1 of 2
Instrument

Components:

x4
M8 Barrel Nuts
x4
Eye Straps
x8
x4
M6x20mm
M8 Square Nut
Secure Screw
x4
x4
M6x12mm
M8 Nyloc Nut
Secure Screw
Metric Conversion:
250mm/ 10"
550mm/ 22"
1240mm/ 49"
1.5m/ 59"
BS EN 1176
(1.1)
Weight of heaviest part
13kg
(Notes)
Surface Fix
Pair Small Red
Beaters X4
Components:
1. Attach Surface Plates to
base of each leg. (1.1) (See
Assembly Guide)
2. Use wooden jig to mark out
hole positions for each of the 3
legs in desired location upon
decision from customer. .
3. Fix to Surface using
recommended ground
anchors (Ground Anchors are
not supplied)
4. Make sure all fixings are
covered and secure using
cover caps provided
5. Once frame fixed in place
install notes using Fixings
provided. Finally install
beaters using fixings provided.
(See Assembly Guide)
x3
x3
M10x40 Security Screw
M10 Barrel Nut
2 Part Cover Cap
1.5m
1240
Ground Surface
Spares available from
Ground Anchors
x12
percussionplay.com
not supplied
local distributor
1.5m
Install Instrument
with 1.5m free space
(from widest point)
around it.
CAUTION: Papilio
surface can get hot
in direct sunlight, if
possible install in
shaded areas.
36 Kg
or from your

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Papilio Bells PPBUTR and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Percussion Play Papilio Bells PPBUTR

  • Page 1 Installation Instructions 1. Attach Surface Plates to (1.1) base of each leg. (1.1) (See Assembly Guide) 1.5m 1.5m Surface Fixed 2. Use wooden jig to mark out hole positions for each of the 3 Papilio Bells legs in desired location upon Page 1 of 2 decision from customer.
  • Page 2 Assembly Guide PPBUT R Tools: TX 30 Driver Bit TX 40 Driver Bit TX 45 Driver Bit Thread Lock Solution Required (Not Supplied) Surface Fixed Papilio Bells Page 2 of 2 (1.1) Attach notes to Instrument centre post Components: using 2 access holes in leg M8 Barrel Nuts Eye Straps...

Table of Contents