JRC JQE-103 Operation Manual page 34

3) Insert the top of antenna on cushion B
Antenna
Insert this part
Cushion B
Fig.3-7e Mounting antenna to cushion B
(3) Put the mount cover on the mount base from bottom side, and fasten the belt over the mount cover to do
not bend, and fasten with catch clip. Then, insert the lock pin to the catch clip.
The hydraulic pressure sensor is made of resin, and it may be damaged by excessive impact or stress.
Be careful not to give too much impact or stress to it.
Fig.3-7f Fixing Catch clip
3-10