Test - JRC JQE-103 Operation Manual

3-6 Test

This unit has the following test functions. It is recommended to perform this test once a week at the condition
installed in bracket. Set the selector switch to "TEST" for performing this test. The selector switch can be
turned to "TEST" without releasing the stopper.
Stopper pin
Stopper
Selector switch
Test contents
position
TEST
Check the
battery
voltage *1
Emission
check of
406.028MHz
Check the
Indicator
lamp
READY
Satellite EPIRB is in the normal status when results of above tests are normal.
Fig.3-6 Position of the Selector switch when test is ongoing
Satellite EPIRB status
Yellow LED and orange
LED light for 4 sec.
Yellow LED and orange
LED blink for 4 sec. in 0.5
sec. interval.
Yellow LED and orange
LED blink for 4 sec. in
0.1sec. interval.
Yellow LED and red LED
light for 0.44 sec.
Yellow LED lights for 0.44
sec.
(Red LED does not light.)
LED does not light at all.
Indicator lamp flashes at
2.6 sec. Interval.
Indicator lamp does not
flash.
-
Selector switch
The battery voltage is
normal.
The battery is
somewhat consumed.
The battery is
exhausted.
406.028MHz
transmitter is normal.
The signal is not
transmitted though
the SYNTH circuit
works.
Malfunction of
the transmitter.
The indicator lamp
is normal.
Malfunction of the
indicator lamp.
-
3-6
Indicator lamp
Test result
Contact
purchased
dealer or JRC
Contact
purchased
dealer or JRC
Contact
purchased
dealer or JRC
Contact
purchased
dealer or JRC
Contact
purchased
dealer or JRC
-
Orange LED
Yellow LED
Red LED
Action
-
-
-
-