Functional And Configuration Mode - Bosch CL550 Configuration And Commissioning Software Manual

System Introduction
2–18
2.2.8

Functional and Configuration Mode

Select mode
In functional and configuration mode, the following settings are available:
Display Display
Dev status
.
The active fixation and the disabled outputs are immediately displayed
by the assigned LEDs.
Press the SELECT button until the upper display shows "C".
L
Dev
Description
Cancel fixation
Overlay non-remanent start-up, reset remanence error
Release output
Outputs disabled
Serial interface has been assigned with BUEP19E
Serial interface assigned by tracer (Job reporting)
Cancel MPS of DP busmaster part selectively
Cancel all stored data
(PLC program, I/O configuration, IP configuration)
Software version of ZS550
(available from V1.1 or higher)
1070 072 262-101 (01.09) GB