Table of Contents
Advertisement
AUTO-DARKENING HELMET SECTION
HELMET INFORMATION
This auto darkening welding helmet with integrated
clear face shield is an all-in-one solution for welding,
cutting and grinding. It is designed to provide protection
from harmful UV and IR radiation from welding/cutting
process with the lens flip down, and help protect
against flying particles from grinding with the lens flip
up. This Helmet can be used for GMAW, GTAW,
MMAW welding, or Plasma Arc and air carbon arc
cutting.
This Auto-Darkening Welding Helmet will change from
a light state (shade 4) to a dark state (Shade 5-13)
when arc welding starts. The filter automatically returns
to a light state when the arc stops. Match your welding
application to the shade indicated on the shade chart.
• The lens must flip down before welding.
• Do not use the auto-darkening filter if damaged by
shock, vibration or pressure.
• Do not use the helmet without inside and outside
cover lenses properly installed.
• If cover lens is spattered or covered with dirt, it
should be replaced immediately.
• Do not use helmet if lens does not function as
described.
The cartridge contains four sensors to detect the light
from the welding arc, resulting in the lens darkening to
a selected welding shade. Keep the sensors and solar
cell clean. Clean the filter cartridge using a soapy water
solution and soft cloth which should be damp but not
saturated.
•
Do not use solvents or abrasive cleaning detergent.
•
Use only replacement parts specified in this manual.
VIKING PAPR FGS 3250D WELDING HELMET
15
Advertisement
Table of Contents
