Helmet Information - Lincoln Electric VIKING 3250D FGS Operator's Manual

This auto darkening welding helmet with integrated clear face shield is an all-
in-one solution for welding, cutting and grinding. It is designed to provide
protection from harmful UV and IR radiation from welding/cutting process
with the lens flip down, and help protect against flying particles from grinding
with the lens flip up. This Helmet can be used for GMAW, GTAW, MMAW
welding, or Plasma Arc and air carbon arc cutting.
This Auto-Darkening Welding Helmet will change from a light state (shade 4)
to a dark state (Shade 5-13) when arc welding starts. The filter automatically
returns to a light state when the arc stops. Match your welding application to
the shade indicated on the shade chart.
• The lens must flip down before welding.
• Do not use the auto-darkening filter if damaged by shock, vibration or
pressure.
• Do not use the helmet without inside and outside cover lenses properly
installed.
• If cover lens is spattered or covered with dirt, it should be replaced
immediately.
• Do not use helmet if lens does not function as described.
The cartridge contains four sensors to detect the light from the welding arc,
resulting in the lens darkening to a selected welding shade. Keep the
sensors and solar cell clean. Clean the filter cartridge using a soapy water
solution and soft cloth which should be damp but not saturated.
• Do not use solvents or abrasive cleaning detergent.
• Use only replacement parts specified in this manual.

HELMET INFORMATION

3