Watchguard Firebox M4600 Hardware Manual page 24

Hardware Installation
Install the Firebox in the rack
Use these steps to complete installation of the Firebox in the rack.
1. Pull out the center rail on each side until the extension safety lock is locked.
2. Hold the Firebox with its front facing you. Lift the Firebox and carefully slide the inner rails on each side
of the chassis into the outer rail on each side of the rack.
3. Press the safety lock tabs on the inner rails, and slide the device into the rack until the front mounting
brackets touch the front posts of the rack.
4. Use two of the countersink screws (C), without the washers, to attach the front mounting brackets to
the rack.
Remove the Firebox from the Rack
The rack mount system includes two sets of safety locks that you must press in order to remove the device
from the rack. It could require two people to remove the device from the rack. One safety lock is located on
the inner rail. The other safety lock is located on the center rail.
To remove the Firebox from the rack:
1. Remove any screws that attach the mounting bracket to the front of the rack.
2. Slide the device out about half way until the first safety locks catch on each side.
3. Press the metal safety locks on the inner rails on both sides of the device while you pull the device
farther out.
4. Continue to slide the device out until the second safety locks catch on each side.
5. Press down the safety locks located on the inside of each center rail while you pull the device farther
out.
Slide the device out of the rack.
20
Press in to unlock
Press down to unlock
WatchGuard Firebox M4600