Safety Notices - Watchguard Firebox M4600 Hardware Manual

Safety Notices

All WatchGuard products are designed and tested to meet strict safety requirements. These requirements
include product safety approvals and other global compliance standards. Read these instructions carefully
before you operate the product, and refer to them as needed for continued safe operation of your product.
Product Safety Certification
The WatchGuard product is safety certified for these standards:

CAN/CSA C 22.2 No. 60950-1-07+A1:2011+A2:2014

UL 60950-1:2007 R10.14

IEC 60950-1:2005 (Second Edition) + Am 1:2009 + Am 2:2013

EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013
Safety Warning

Do not place objects on the power cords.

Do not obstruct the ventilation openings. These openings prevent overheating of the device.

Never push objects of any kind into slots or openings on this equipment. If you make contact with a
voltage point or short out a part, it can result in fire or electrical shock.

If the equipment is supplied with a three-conductor AC power cable, the power cable must be plugged
in to an approved three-contact electrical outlet with the grounding wire connected to an electrical
ground (safety ground) at the power outlet.

When you remove or install a device, follow the general installation safety instructions provided in this
Hardware Guide to avoid injury or damage to the device.

The lithium battery used in the security appliance may not be replaced by the user. Return the
appliance to a WatchGuard authorized service center for replacement with the same or equivalent
type recommended by the manufacturer. If, for any reason, the battery or security appliance must be
disposed of, do so following the battery manufacturer's instructions.

You must disconnect power the AC power cord from both power supplies before you remove the
cover of the Firebox for any reason.
Hardware Guide
Hardware Specifications
11