Vanguard SBVBN(C) Operating And Installation Manual page 7

CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
Continued
INSTALLING B-VENT
BURNER SYSTEM INTO
STOVE BODY
1. Carefully lift burner system and place
into stove body from the rear of stove.
2. Place the left and right grate tops into the
top of stove body. Discard center grate
top of stove and replace with center grate
top provided with burner system.
Center Top Grate
(Included with
Burner System)
Right Top
Grate
Left Top
Grate
Cast Iron
Stove Body
Figure 15 - Installing Burner System Into
Cast Iron Stove Body
106828
INSTALLING OPTIONAL
BLOWER ACCESSORY
NOTICE: If installing blower in an
existing stove burner system with
gas connections, shut off gas
supply and disconnect heater
from gas supply. Contact a quali-
fied service person to do this.
1. Remove 4 hex screws securing rear cover
to back of stove body (see Figure 16).
2. Separate bottom cover from rear cover
by loosening the 8 mounting screws
(see Figure 16).
3. Align the holes in the top mounting tabs
of blower with the holes in wall of rear
cover. Using the 4 screws provided,
mount blower and tighten screws se-
curely (see Figure 17).
4. Attach thermal switch and bracket to
inside rear cover wall with two hex
head screws provided as shown in Fig-
ure 17. After securing bracket to rear
cover, carefully bend along existing
bend line on bracket to almost a 90
angle (see Figure 17). This will allow
thermal switch to be positioned against
stove rear wall and sense temperature
when in operating mode.
Stove Body
Burner
System
Figure 16 - Removing Rear Cover and Bottom Cover from Stove Body
OWNER'S MANUAL
Thermal
Switch
and
Bracket
Figure 17 - Blower Assembly, Speed
Control, and Thermal Switch Locations
Hex Screws
Bottom Cover
For more information, visit www.desatech.com
7
Speed
Control
Blower
Control
Control
Knob
Shaft
Locknut
TOP VIEW
Mounting
Holes
Blower
Assembly
Mounting Holes
Rear Cover
Mounting
Screws
Screws
Mounting
Screws
Hex
Screws
Mounting
Screws
Continued