Table of Contents
Advertisement
CAST IRON STOVE AND BURNER SYSTEM
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
INSTALLATION
Continued
INSTALLING LOGS, LAVA
ROCK, AND GLOWING
EMBERS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only parts
specifically approved with this
burner system may result in prop-
erty damage or personal injury.
It is very important to install these logs
exactly as instructed in Figures 43 through
47 . Do not modify logs. Only use logs
supplied with freestanding burner system.
Do not use if any log(s) are broken (see
Replacement Parts, page 26).
1.
Remove glass door. See Removing/Re-
placing Glass Door, page 17.
2.
Place log #1 (back log) on top of grate.
Make sure the notches in the bottom of
the log fit over the grate (see Figure 43).
2.
Rest log #2 (large front log) on the pins on
the front part of the grate (see Figure 44).
3.
Place log #3 (crossover log) onto the
rear and front logs. Make sure it is seated
properly into the notch on the front log
and over the raised triangular portion of
the rear log as shown in Figure 45.
Figure 43 - Installing Log No. 1
For more information, visit www.desatech.com
SBVBN(C) AND SBVBP(C)
®
4.
Place log #4 (small log) onto the front
left part of the grate making sure the
notches fits over the prong of the grate.
See Figure 46.
Figure 44 - Installing Log No. 2
Figure 45 - Installing Log No. 3
Figure 46 - Installing Log No. 4
18
5. Lava rock may be placed along sides
and front inside burner system bottom.
This may not be visible when you have
replaced the front of the stove. It is
not necessary to use all of the lava rock
provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
6.
Pull ember material apart into pieces
no larger than a dime. Place these
pieces loosely and sparingly directly
onto the exposed section of the front
burner and along the space between the
burner and grate prongs (see Figure 47).
This will create the glowing ember ap-
pearance as the flame touches the em-
ber material. Do not block air slots by
using too much ember material in one
area. It is not necessary to use all of the
ember material provided.
7.
Replace the glass door and stove
front. See Removing/Replacing Glass
Door, page 17.
WARNING: The glass door
must be securely in place before
running this burner system. Do
not run this burner system if glass
is missing or broken.
Figure 47 - Placing Ember Material on
Burner
106828
Advertisement
Table of Contents
