Vanguard SBVBN(C) Operating And Installation Manual page 5

CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
STOVE BODY ASSEMBLY
1. Lift off corrugated box enclosing stove
body crating.
2. Remove all screws fastening the wood
frame enclosure. Spread wood frame open
and lift away from plastic-bagged stove
body. The bottom pieces of pallet wood
will remain bolted to the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove and dis-
card (see Figure 6). Use an adjustable
wrench or a 10 mm socket. Remove six
(6) bolts and washers. Keep bolts and
washers to reattach rear cover.
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom (Discard - Not used
with this application)
(4) - Legs with leg leveler bolts
(1) - Bottom door
(3) - Top grates
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to at-
tach bottom components to stove body
(see Figure 7). Rest stove on drop cloth or
blanket to avoid scratching stove edges.
7. Remove remaining pallet wood at-
tached to bottom of stove body (see
Figure 8). Use an adjustable wrench to
remove bolts.
8. Fasten each leg to stove with four (4)
M8 x 1.25 - 20mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figure 9 and Figure 10
on page 6). Use an adjustable wrench
or a 12mm socket.
106828
Bolt
Product
Identification
Back
Label
Stove
Panel
Figure 6 - Removing Back Panel
Top of Stove Unit
Front of
Stove
Unit
Drop
Cloth/
Blanket
Figure 7 - Laying Down Stove On Side
Bolt Front
Pallet Wood
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
Door Hinge Step
Bolt Hole
Leg Hole
Bottom Of
Stove Unit
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
5
OWNER'S MANUAL
Front of
Stove Unit
Pallet
Wood
Bolted to
Bottom of
Stove
Body
Pallet Wood
Bottom Of
Stove Unit
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Front
Leg Hole
For more information, visit www.desatech.com
Top of
Stove
Unit
Leg Hole
Continued