Rear Panel - Phonic A6600B User Manual


8. Frequency Slide Controls
These 31 small faders allow users to adjust each
frequency band of the audio individually. At the "0"
position, the frequency will not be processed. Slide a
control up to boost that particular frequency; down to
attenuate it.
6

Rear Panel

9. Power Switch
Flicking this switch will turn the A6600B
equalizer on and off. Remember to keep
the power switch in the "off" position when
connecting or disconnecting the power
cord to the unit.
10. Power Connector
Used for the addition of a power
cable and supply, allowing power
to be supplied to the mixer. Please
use the power cable that is included
with this mixer only.
holder, located above the AC Power
connector, is for the A6600B's fuse.
If the fuse happens to blow, open the
holder cover, and replace the fuse
with a suitable replacement (as indicated next to the
power connector).
11. Input Connectors
These balanced 1/4" TRS and XLR jacks are used for
receiving signals to be sent to each input channel.
12. Output Connectors
These output connectors, the same as featured on the
input, send their corresponding signals. All outputs run
in parallel to one another (meaning you can use the
1/4" and XLR outputs at the same time).
13. Subwoofer Output
The balanced subwoofer output connector can sends
the summed signal of the main left and right signals to a
subwoofer. The signal sent from the subwoofer output
has been processed by the internal crossover.
14. X-Over Frequency Control
This switch allows users to adjust the cross-over
frequency of the subwoofer output. This function
ensures that your subwoofer amplifier needs only
process the low-frequency audio that you want sent
to the subwoofer.
12
13
9
10
The Fuse
11
1
A6600B
12