Connect Electrical Supply - Bosch HDS8055U Installation Manual

WARNING
9
The rear vent trim has 3/16" (5 mm) standoffs to
keep the appliance slightly off of the back wall.
Do not remove or tamper with standoffs due to
potential temperature issues.
Check for proper installation and use of the anti-tip
10.
bracket. Carefully tip the range forward pulling from
the back to ensure that the anti-tip bracket engages
the range leg and prevents tip-over. The range should
not move more than 1" (2.5cm).

Connect Electrical Supply

The Dual Fuel slide in range may be connected using an
electric range cord or using a flexible conduit electrical
connection. The length must be at least 1,5 m.
For technical specifications see the rating label on the
underside of the projecting control panel.
Do not use multiple outlets, extension leads or adapters.
Notes
In Canada, the range is shipped from the factory with
▯
the range cord already installed.
We recommend that only qualified persons add a
▯
power cord or make electrical connections to this
appliance.
For installations other than those in Canada, connect the
range cord at the terminal block. Access the terminal
block by removing the cover in the lower right-hand
corner of the range back panel.
WARNING
9
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance (HDS8..5C) is equipped with a four-
prong grounding plug for your protection against
shock hazard and should be plugged directly into a
properly grounded receptacle. Do not cut or remove
the grounding prong from this plug.
16
Preparation for Power Connection
WARNING
9
WARNING
Risk of Electric Shock or Fire. Grounding through
the neutral conductor is prohibited for new branch-
circuit installations (1996 NEC), mobile homes, and
recreational vehicles, or in an area where local
codes prohibit grounding through the neutral
conductor.
For installations where grounding through the neutral
conductor is prohibited: (a) disconnect the link from the
neutral, (b) use grounding terminal or lead to ground
unit, (c) connect neutral terminal to lead branch circuit
neutral in the usual manner. When the appliance is to be
connected by means of a cord kit, use 4-conductor cord
for this purpose.
Use only cord kits rated 208/240 volts, 50 amperes, with
ring or fork type connector and labelled "For use with
ranges". Use only flexible conduit with wires with ring or
fork type connectors. Strain relief provided with the cord
must be installed per instructions included with the cord.
3-Wire Hookup
R= Red
W = White
GS = Grounding Strip
B = Black
WARNING
9
WARNING
To prevent electrical shock, the grounding prong on
the range cord should not be cut or removed under
any circumstances. It must be plugged into a
matching grounding type receptacle and connected
to a correctly polarized 240-Volt circuit. If there is
any doubt as to whether the wall receptacle is
properly grounded, have it checked by a qualified
electrician.
4-Wire Hookup
R= Red
W = White
G = Green
B = Black