Eaton S801T Instructions For Installing

The typical kit includes three lugs or bus interfaces with hardware for line or load side mounting on the S801T,
S801U,S801V, S811T, S811U or S811V frame. There are two screw lengths included with the typical kit. The 2 inch
screws are used for line side mounting. The 3 inch screws are used for load side mounting.
The EML40, universal lug kit, includes separate bus interface components and hardware. 1.75 inch screws are used
for line side mounting. 2.75 inch screws are used for load side mounting.
EML22
200mm
EML23
S801T/
EML24
S811T
EML25
S801U/
EML26
S811U
EML50
EML28
EML30
290mm EML32
S801V/ EML33
S811V EML40
EML51A
EML51B
* Requires special lug cover. Check with EATON | Cutler-Hammer for availability.
Effective 05/06
2 4-1/0 (21.2-53.5mm²)
1 4/0 - 500 MCM (107-240mm²)
2 4/0 - 500 MCM (107-150mm²)
1 2/0 - 300 MCM (70-150mm²)
2 2/0 - 300 MCM (70-150mm²)
1.75” BUS
2 4/0 - 500 MCM (107-240mm²)
4 4/0 - 500 MCM (107-240mm²)
6 * 4/0 - 500 MCM (107-240mm²)
4 2/0 - 300 MCM (70-150mm²)
4 4/0 - 500 MCM (107-240mm²)
2.00” BUS
3.00” BUS
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
25,5 N-m (225 LB-IN)
25,5 N-m (225 LB-IN)
N/A
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
28,3 N-m (250 LB-IN)
25,5 N-m (225 LB-IN)
34,0 N-m (300 LB-IN)
N/A
N/A
2
N/A
2
N/A
N/A
Revision 01