Advertisement
Install
Airfit UB
STEP 1: Remove the mast grommet then use a 3mm
allen key to remove the two (2) M6 x 16mm screws
securing the user right shroud to the frame.
STEP 3: Use a 3mm allen key to remove the four (4)
M5 x 12mm screws securing the user left side shroud
to the frame, then remove the shroud.
STEP 2: Remove the user right side shroud by using a
#2 phillips screwdriver to remove the three (3) #8-18
x 1.25" screws then use a 3mm allen key to remove
the two (2) M5 x 16mm screws. Finally, use a 5mm
allen key to remove the one (1) M8 x 20mm screw
securing the shroud to the frame.
STEP 4: Remove the console grommet and the
Console Adapter Cable from the console mount then
connect the long Console Power Cable (the short
cable is used for the HIITMills) to the Console Adapt-
er Cable.
NOTE: There should only be one input available
on the Console Adapter Cable as the other end is
plugged into the RPM sensor.
Page 2
620-8587 Rev. C
Advertisement
