Table of Contents
Advertisement
ACCESSORy
INSTALLATION
Continued
Removing Bifold Glass Doors
Bifold doors may be removed for replacing
or cleaning.
1. Partially open each door and press up on
upper spring clip with a screw driver until
outer top pivot pin is free of the clip.
2. Fully fold frame assembly and slide upper
edge towards center of firebox opening
until the guide pins are free of the frame
rail (see Figure 15, page 8).
Installing Series Fixed Glass Doors
1. Hold glass door firmly at both handles and
insert top pins into clips located below up-
per facial edge of firebox opening. Make
sure top pins snap securely into holes on
spring clips (see Figure 17).
2. Push up on glass against tension of spring
clips. Swing lower door into face until lower
pins clear bottom rail and set into locating
holes on each end (see Figure 17).
Note: If pins do not align into spring clips,
slightly loosen retaining screws on each clip
(see Figure 16, page 8). Reinsert panel into
each spring clip and align panel into lower
locating holes. Remove panel, finish tighten
screws and reinsert panel.
Figure 17 - Installing Fixed Glass Doors
115121-01B
OPTIONAL BRICk LINERS
Installing or Removing Brick Liner Kits
Brick liner kits are available for Models
VE36/32(L)(H) (see Accessories, page 23).
These brick panels may be installed anytime
after fireplace installation is complete.
Follow these steps to install left and right
brick panels:
1. Remove glass doors (if equipped). Follow
2. Remove each retaining screw holding
3. Remove log bed from hearth pan and
4. Remove two screws holding each refrac-
Locating
Spring Clip
Holes
Locating
Hole
www.desatech.com
instructions under Optional Glass Doors,
page 8.
screen rods and pull entire screen and rod
assembly out of locating hole on inside top
edge of firebox (see Figure 18).
place in a safe area. Log bed is attached
with contact magnets only.
tory bracket to firebox. Pull up and lift out
of positioning slot at bottom of hearth pan
(see Figure 19, page 10). Note: VE36L
and VE36LH models require removal of
additional hearth brackets and face panels
which are held in place by 2 screws on
hearth pan and one screw at top retainer
bracket (see Figure 19, page 10).
Screen
Rod
Retaining
Screw
Figure 18 - Removing Screen/Rod
Assembly
9
Advertisement
Table of Contents
