Vanguard VE32L Owner's Operation And Installation Manual page 10

ACCESSORy
INSTALLATION
Continued
5. Insert brick panel, beveled edge first,
through firebox opening. Tilt and angle top
edge into brick retainer until beveled edge
contacts imager and panel is flat against
firebox (see Figure 20).
6. Align hearth pan bracket over holes near
lower edge of brick panel and secure with
2 pan screws provided.
7. Replace refractory bracket using 2 screws
removed in step 4, page 9.
8. Repeat steps 5 through 7 for opposite
panel assembly.
9. Replace each screen assembly by po-
sitioning screen rod into locating holes
under top edge of firebox and securing
with 2 Phillips screws removed in step
2, page 9. Note: Rods may have to be
angled into locating holes at the top of
each screen pocket. Once inserted, pull
free end of rod forward until it lines up
over farthest mounting hole respectively
so rods overlap.
10. Replace log bed over hearth opening
and center between grate and viewing
screen.
11. Replace glass doors if removed. See
Optional Glass Doors, page 8.
Face Panel
(Models VE36L
and VE36LH
Only)
Refractory
Hearth Pan Bracket
Bracket
(Models VE36L and
VE36LH Only)
Figure 19 - Removing Refractory Bracket
and Hearth Pan Bracket
10
Refractory
Bracket
Figure 20 - Installing Brick Panels and
OPTIONAL HEATER ACCESSORY
power before attempting any
maintenance or cleaning to re-
duce the risk of fire, electrical
shock or personal injury.
Blower/heater kit model BHKE is available
for models VE36/32L and VE36/32LB. Either
of 2 types of blower/heater assemblies can
be installed.
1. Open upper control door (see Figure 13,
on page 7) and remove 2 Phillips screws
below heater grill on control panel (see
Figure 21, page 11).
2. Remove 2 Phillips screws holding control
cover to control panel inside firebox (see
Figure 14, page 8).
3. Slide control cover to the right and swing
out locking tabs from notched openings
on top (see Figure 21, page 11) .
4. Let control cover hang down off har-
nesses. Be careful not to damage any
wiring. If necessary, unscrew harness
strap at blower mount to gain slack.
5. Remove 2 hex screws at rear of blower
mount (see Figure 21, page 11).
6. Slide blower mount towards rear of firebox
until locking tabs line up with notched
openings and lower mount down and
away (see Figure 21, page 11).
www.desatech.com
Hearth Pan
Bracket
Brackets
WARNING: Disconnect
Refractory
Retainer
Bracket
115121-01B