Table of Contents
Advertisement
MAINTENANCE
Continued
REPLACING LAMP FIxTURES
Lamp fixtures may be replaced as follows:
1. Turn off all power to fireplace at circuit
breaker or fuse.
2. Locate any of 3 defective lamp fixtures
and trace wiring to crimp connectors in
harness and disconnect.
3. Remove 2 crimp connectors in harness
and disconnect white and black wires on
defective fixture. See Wiring Diagram, Fig-
ure 28 on page 14, for proper locations.
4. Remove 2 Phillips screws at base of
defective fixture (see Figure 39).
5. Remove old fixture and mount new fixture
with 2 Phillips screws removed prior.
6. Twist bare ends of white and black wires
to corresponding wires in main harness
and secure them with 2 crimp connectors
provided.
Screws and
Washers
Reflective
Ribbon
Bottom Hanger
Bracket
Screws
Lamp
Fixture
Crimp
Connectors
Figure 39 - Replacing Fixtures (Shown without FIrebox for Clarity)
20
Upper Hanger
Bracket
Hanger
Screws
Reflective
Ribbon
Base
Cover
www.desatech.com
Note: There should be no exposed bare
wire at any connection. Wiring should be
secured with wire ties, as short as possible,
and kept away from fan blades. If additional
parts are required, see Replacement Parts,
on page 22.
7. Replace each light bulb with proper color,
(see Replacing Light Bulbs, page 14).
8. Restore power and check lamp circuit op-
eration before reassembling imaging unit.
9. Reassemble imager. See Accessing
Imaging Unit, page 16.
Make sure power is turned off
at supply prior to disassembling
this unit.
IMPORTANT: Be sure to inspect components
and wiring for damage before connecting
power to unit. If any components are found
damaged, contact an authorized dealer for
original DESA replacement part(s) or call
DESA at 1-866-872-6040 for referral.
Ribbon Support
Bracket
Cellophane
Tape
115121-01B
Advertisement
Table of Contents
