Table of Contents
Advertisement
MAINTENANCE
Continued
Base
Cover
Figure 36 - Removing Base Cover
SERvICING FAN BLOWER
To remove fan blower:
1. Follow instructions under Accessing Imag-
ing Unit, page 17.
2. Remove 3 light bulbs from lamp fixtures
(see Replacing Light Bulbs, page 15).
3. Disconnect two 1/4" blade connectors
from posts on motor unit.
4. Remove 4 hex nuts and washers located
on blower mounts at base of cabinet (see
Figure 37).
Hex Nut
Washer
Spacer
Screw
Fan Assembly
Posts for Blade
Connectors
Figure 37 - Removing Fan Assembly (Shown without Firebox for Clarity)
18
5. Lift entire fan assembly off of mounts and
6. Remove screws with washers and hex
7. Mount new fan to blower mount in reverse
8. Slide blower assembly with spacers over
9. Attach blade connectors to posts on
SERvICING FLAME PENNANTS
If flame pennants should become tangled or
detached reattach or replace.
1. Locate affected flame pennant. Slip hem
2. Pull flame cord up to proper hook location,
3. Tie another knot over slip knot and trim
Washer Hex
Blower
Nut
Mount
(1 of 4)
www.desatech.com
tilt out of unit.
nuts from fan housing.
order.
mounting lugs and replace washer and
nut at each lug. Do not over tighten.
motor mount. Note: Wire connectors for
fan motor are non-polarized and may be
connected to either terminal for proper
operation.
at base of flame pennant over proper
hanger bracket position. See Figure 38,
page 19, for proper location.
use a slip knot to adjust cord length and
attach cord to hook.
away excess cord.
115121-01B
Advertisement
Table of Contents
