Chapter 3: Installation Instructions - MacDon FM100 Installation Instructions Manual

Chapter 3: Installation Instructions

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine and remove
key before leaving the operator's seat, and always engage safety props before going under the machine for any reason.
To install the Dual Sensor AHHC kit (MD #B6211), follow these steps:
NOTE:
Unless otherwise stated, all parts are provided in the kit.
1. Raise the reel to full height, and engage the safety props.
NOTE:
The header is removed from the illustrations for clarity. The kit is installed with the float module attached to the
header.
2. Shut down the combine, and remove the key from the ignition.
IMPORTANT:
Before installing the sensor assemblies, make sure you correctly identify which assembly is for the left side and which
assembly is for the right side. The sensor assemblies MUST be installed in the correct locations for the dual sensor
system to work correctly.
3. Hold up the assembly so that the sensor connector (A) is
pointing down and the mounting bolt heads (B) are facing
away from you.
• The left sensor assembly (L) has the linkage (C) to the
left of the sensor.
• The right sensor assembly (R) has the linkage (C) to the
right of the sensor.
214143
L
C
R
B
Figure 3.1: Left and Right Sensor Assemblies
7
B
A
A
Revision F
C