HP ProBook x360 435 G7 Maintenance And Service Manual page 54

3. Remove the battery (see
4. Remove the fan (see
When you replace the system board, be sure to remove the following components (as applicable) from the
defective system board and install them on the replacement system board:
Memory modules (see
●
WLAN module (see
●
Heat sink (see
●
Remove the system board:
1. Disconnect the following cables from the system board:
Power connector cable (1)
●
Display cable (2)
●
Speaker cable (3)
●
Antenna cables from the WLAN module (4)
●
● Display cable (5)
● Camera cable (ZIF) (6)
Touchpad cable (reverse ZIF) (7)
●
Keyboard cable (reverse ZIF) (8)
●
Keyboard backlight cable (reverse ZIF) (9)
●
Fingerprint reader cable (reverse ZIF) (10)
●
● RTC battery cable (11)
2. Remove the five Phillips M2.0 × 2.5 screws (1) that secure the system board to the computer.
3. Remove the three Phillips M2.0 × 5.0 screws (2) from the plastic bracket, and then remove the bracket
(3).
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
Battery on page
Fan on page 41).
Memory modules on page
WLAN module on page
Heat sink on page 42).
30).
34).
37).