Table 5-3
Touchpad description and part number
Description
NOTE:
The touchpad cable is available in the Cable Kit, spare part number M03431-001.
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover
3.
Remove the battery (see
Remove the touchpad:
1.
Disconnect the cable from the ZIF connector on the touchpad (1).
2.
Lift the protective shielding from the top of the touchpad (2).
3.
Remove the four Phillips M2.0 × 3.0 screws (3) that secure the touchpad to the computer.
4.
Remove the Phillips M1.6 × 2.0 screw (4) that secures the touchpad to the computer.
5.
Remove the touchpad from the computer (5).
Reverse this procedure to install the touchpad.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-4
Solid-state drive descriptions and part numbers
Description
512 GB, PCIe, TLC
512 GB, PCIe, value
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page
29).
Battery on page
30).
Spare part number
29).
Spare part number
L85360-002
L85364-002