Front And Rear View; System Indicator Leds - NETGEAR ProSafe WFS709TP Hardware Installation Manual

WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
• 1U chassis can be mounted in a standard 19-inch network equipment rack.
• The firmware can be easily upgraded as future software releases are made available. You can
install upgrades using HTTP.

Front and Rear View

The standard version of the WFS709TP ProSafe Smart Wireless Switch contains a 1000BASE-T
copper Gigabit Ethernet (GE) connector. Figure 1-1 shows the front and rear views of the switch.
Figure 1-1

System Indicator LEDs

The system LEDs, located on the front of the switch, display the status of system power and
operation.
Table 1-1. System LEDs
LED State
Power Green
Off
Status Green
Off
1-2
1
Description
WFS709TP is receiving proper power.
WFS709TP is powered off.
WFS709TP has booted and is functioning properly.
WFS709TP is booting, loading software, or has failed.
Note: This LED remains off until you perform the
initial setup described in the document Installation
Guide: WFS709TP ProSafe Smart Wireless Switch.
v1.0, May 2007
Introduction