Essential Safety Instructions - ENGIE EPS easyWallbox User Manual

GB
2.
SAFETY
2.1. Intended purpose of easyWallbox
easyWallbox
is only intended for fixed mounting. It can be installed and
used to charge electric vehicles both indoor (garages, company depots
with restricted access, etc.) and outdoor (private land, car parks, etc.), in
compliance with chapter 4 indications and local regulations.
The device can be used exclusively to charge full-electric or hybrid
vehicles compatible with Type 2 connectors, as in IEC 62196-2; it is not
compliant with other vehicles or devices.
Equipment. Therefore, it requires a proper earthing connection, by plug
and socket-outlet. The optional function for ventilation is not
supported by easyWallbox. Some countries apply regulations that require
supplementary protection from the risk of electrocution. In any case,
the instructions for use in the manual and any additional documentation
must be read before using easyWallbox.
connected to a power supply protected by an RCD and an overcurrent
protective device. The RCD should have a rated residual operating
current not exceeding 30 mA, be at least type A, and should comply
with one of the following standards: IEC 61008-1, IEC 61009-1, IEC 60947-2
and IEC 62423. The overcurrent protective devices should comply
with IEC 60947-2, IEC 60947-6-2, IEC 61009-1 or the relevant parts of
IEC 60898 series or IEC 60269 series.
2.2. Use not in accordance with the intended purpose
easyWallbox
Use of is only safe if it conforms to the intended purpose.
Different use and unauthorised modifications to the device are considered
as non-compliant and so unacceptable. The user is responsible for the
use and is liable for any dangerous situations or situations contrary to
the legal provisions applied in their country.
ENGIE Eps does not assume any liability for damage caused by
non-compliant use or unauthorised modifications to the device.
46
easyWallbox is a piece of Class I
easyWallbox
should be
2.3.

Essential safety instructions

easyWallbox was designed, built and checked in compliance with the
current safety regulations. Installation of
be made directly by users capable of understanding and following
carefully the present instructions and able to evaluate and understand
all related risks. ENGIE Eps does not assume any liability for damage to
persons or things that may arise from failure to respect the safety
regulations and the instructions in this manual.
2.3.1. Respect for local conditions
easyWallbox
The operational safety of
which must respect current legislation.
Incorrect installation may cause danger such as serious injury
or death.
2.3.2. Respecting the supervision requirement
Children and people not able to evaluate, even momentarily, the possible
risks arising from the incorrect use of
the device and the charging cable, both when in use and non-operational.
2.3.3. Regulatory status
easyWallbox must be maintained intact. If there is any damage or
defects, users run the risk of serious injury caused by electric shocks.
Therefore, follow the instructions below:
avoid knocking the device

avoid use not in accordance with the intended purpose

incorrect use of the device

clearly indicate the malfunction of the device so that other people

will not use it
ask for the prompt intervention of qualified personnel to repair

damage or defects
Use of easyWallbox during a strong thunderstorm is not
recommended.
GB
easyWallbox
in Mode 2 can
depends on its correct installation
easyWallbox
must be kept away from
47