Table of Contents
Advertisement
2.0 Touch Controller Installation
The Touch Controller is connected to a compatible appliance
through the Interface Module.
Communication Loom (P&C Loom), connects the Touch
Controller to the Interface Module. The Power Transformer
(12VDC) supplies power to the Interface Module.
Diagram 4: Connection Diagram
Power Transformer
12DC 1.5m loom
Appliance
(supplied)
(field supplied)
(field supplied
GPO)
Weatherproof
enclosure for
external GPO
(field supplied)
A 20m, four core, Power &
(0.75mm
figure -8 cable
2
field supplied)
Touch Contoller
(supplied)
Power & Communication
(Loom 20m supplied)
Interface
Module
(supplied)
Isolation Switch
To connect the appliance to the Touch Controller:
1. Determine location of the Touch Controller.
2. Determine location of the Interface Module.
3. Install the Touch Controller.
4. Install Interface Module.
5. Connect Interface Module to Appliance.
2.1 Location of the Touch Controller
For proper operation the Touch Controller must accurately
monitor the temperature in the space it controls.
Guidelines:
The Touch Controller should be mounted:
• Approximately 1.5m above floor level (ensure hole into wall
cavity is properly sealed).
• Close to the centre of the living space on an internal wall.
• On a section of wall that does not contain pipes, electrical wires,
antenna cables or ductwork.
The Touch Controller should NOT be mounted:
• Where it is exposed to direct sunlight or other heat sources
which may cause a false reading.
• Near or in the path of supply air outlets or return air grilles.
• On outside walls, near windows or doors leading to outside.
• In areas with poor air circulation such as recesses or behind
doors.
Note: Do not install the wiring with the power turned on, as the
fuse may blow, which is not be covered under warranty.
Note: When there are multiple Touch Controllers on a system,
always ensure that the location of each is within 20m of the
Interface Module
6
Hide quick links:
Advertisement
Table of Contents
