When accessing the CUSTOM SETUP screen through a Slave
Touch Controller the following option will be available.
1. Reset the identification of the Touch Controller, refer Diagram
17.
Diagram 17: Slave Touch Controller INSTALLER SETUP
3.4 Reset Networker ID
On either the Master Touch Controller or Slave Touch
Controller, pressing Reset Networker ID, refer Diagram 17,
initiates a prompt to confirm clearing of its identification (address),
refer Diagram 18.
Accepting this change clears the unit
identification and the Touch Controller is forced to restart.
Upon restarting the user is prompted to set the new identification
number as shown in Diagram 19. The unit identification number
shall be in the range from 1 to 10 inclusive, and once entered
press BACK to save and return to INSTALLER SETUP Screen.
Diagram 18: Confirmation to prompt ID change
Diagram 19: Set Networker Address
13