Advertisement
Box: PLOCK 1
BIKE
HONDA CBR 1000 RR
YEAR
2008 - ON
NOTES
Bung and copper washer to be replaced by OE lambda
probe. (not applicable to non catalyst models)
CONTINUED FROM OVERLEAF:
I
K
M
PART NO.
FIT KITS
FEATURES
J
L
N
FITTING INSTRUCTIONS 3/3
EHA - 95
EHA - 95
DB KILLER Z038.10127
I) Sild the underbelly box onto the
original pipework and tighten up
the clamp.
J) Tighten up the bolt into
mounting bracket.
K) For cat model bikes, re fit
lambda sensor in mounting boss
and tighten.
For none cat models, tuse the bung
provided to put into the lambda
boss and tighten up.
With the underbelly box, lambda
sensor on and all tightend up you
can now fasten the fairing back
into place.
L) Fit the Scorpion silencer onto the
outlet of the underbelly box .
M) Bolt through bracket onto
footrest. When silencers are
aligned tighten both the clamp
and bracket.
N) Fit scorpion supplied infill panel
and tighten up 3 bolts. Ensuring
that 2 holes under silencer are
aligned first. Fibre washers MUST
be used between panel and
underbelly silencer.
When all the above steps have
been completed doble check all
nuts and bolts are tight and that
all original bike functions are not
impaired. When satisfied fitment
is correct take your bike for a short
run to ensure system is sealed
correctly and there are no gas
leaks. After a short run, allow your
bike to cool and check all nuts and
bolts are tight.
scorpion-exhausts.com
Advertisement
