Table of Contents
Advertisement
RX3i Ethernet Interface Module IC695ETM001-HV IPI
February 2016
Module Installation
The ETM001 must be installed in the main (CPU) rack of an RX3i system, using a Universal Backplane such as
IC695CHS007, CHS012 or CHS016. The ETM001 supports insertion/removal while power is applied to the system (hot
swap). This module is compatible with all RX3i CPU models.
1.
RX3i rack power may be off or on ("hot insertion").
2.
Holding the module firmly, align the module with the correct slot and connector, then swing the module
down until the module's connector engages the backplane's backplane connector. Visually inspect the
module to be sure it is properly seated.
3.
Insert the two provided M3x5mm machine screws through the module's bottom bracket into threaded
holes in the bottom of the backplate and screw them several turns using a #1 Phillips screwdriver. Tighten
to 0.7 N-m (6 in-lbs).
Related Documents
For additional information about the Ethernet Interface Module, refer to the following publications:
GFK-2314, PACSystems RX3i System Manual
GFK-2224, TCP/IP Ethernet Communications for PACSystems
GFK-2225, PACSystems TCP/IP Communications, Station Manager Manual
Additional Support
For support and information, visit GE Intelligent Platforms' website at http://www.ge-ip.com. The files for this
manual and other related documentation are available there. Additional region- and language-specific websites
and telephone numbers are found there as well.
5
GFK-2332W
Hide quick links:
Advertisement
Table of Contents
