Specifications; Ethernet Interface Status Bits - GE IC695ETM001 Manual

2
GFK-2332W
IC695ETM001 Specifications
Ethernet processor speed
Connectors
LAN
Number of IP addresses
Number of Ethernet Port
Connectors
Embedded Ethernet Switch
Serial Port
Refer to the PACSystems RX3i System Manual, GFK-2314, for product standards and general specifications.

Ethernet Interface Status Bits

Note: Unless LAN Interface OK (Status Bit 16) is set, the other status bits are invalid.
7-8
10–12
13
14
15
16
17
18
79
80
RX3i Ethernet Interface Module IC695ETM001-HV IPI
200 MHz
- Station Manager (RS-232) Port: 9-pin female D-connector
- Two 10BaseT / 100BaseTX Ports: 8-pin female shielded RJ-45
IEEE 802.2 Logical Link Control Class I
IEEE 802.3 CSMA/CD Medium Access Control 10/100 Mbps
One
Two. both are 10BaseT / 100BaseTX with auto-sensing RJ-45 connection.
Yes – Allows daisy-chaining of Ethernet nodes.
Station Manager Port:
LAN Interface Status Bits
1 Port 1A full duplex
2 Port 1A 100Mbps
3 Port 1B full duplex
4 Port 1B 100 Mbps
5 Network Time Locked
6 Redundant IP address is active
Reserved
9 Any Channel Error (error on any channel)
Reserved
LAN OK
Resource problem
Module Overtemperature
LAN Interface OK
Channel Status Bits (Two for each channel)
Channel 1 Status (SRTP: Data Transfer)
Channel 1 Status (SRTP: Channel Error)
... ...
Channel 32 Status (SRTP: Data Transfer)
Channel 32 Status (SRTP: Channel Error)
RS-232 DCE, 1200 – 115,200 bps.
February 2016