GOLDEN MASK DEEP HUNTER PRO Manual page 6

GM Electronics Ltd.
7. Lift the antenna above ground surface to the height at which it will be used
during the search (about 10 cm).
If after lifting the antenna needle on the meter "SIGNAL" deviate to the left of
the position "0", this means that under the antenna was metallic object and the
initial setting is not performed correctly. Move the antenna to another location
and repeat actions 1 to 7.
8. Press and relies button "RETUNE".
9. By the potentiometer "CRACKLE On/Off" can be tuned the frequency of
the sound that will be heard during the searching when there are no metal in the
antenna area.
When there are the presence of a metal object within the scope of the search
antenna this sound began to increase in frequency. In order to detect the
smallest changes in the frequency of the sound indication it is very important
the choice of initial frequency tuning. This setting is highly individualized and
performed "by ear." While working with the accumulation of experience
operator will establish the most appropriate setting for yourself.
10. Again pressure for a short time and release button "RETUNE".
After completion of the above actions setting is completed and the detector
can be used to detect metal objects.
5. Search for metal objects with frame antenna
Golden mask Deep Hunter pro is designed to be used with big size antenna
type "frame". This is the main way to search for deeply buried metal objects.
The antenna should be moved slowly at a constant height (about 10 cm or
more) above the ground. Antennas type "frame" is delivered in the form of
"antenna cable" in length corresponding to the respective size of the frame and
Golden Mask Deep Hunter pro2 – Instruction Manual
6