Subscribe to Our Youtube Channel
Related Manuals for GOLDEN MASK 5
Summary of Contents for GOLDEN MASK 5
- Page 1 Golden Mask BITONAL IRON FOIL NICKEL COPPER SILVER User Guide...
-
Page 2: All Rights Reserved
The Golden Mask 5 has the following features, that place it within the top machines on the market: • High sensitivity •... - Page 3 Main Parts and Assembly Operating the Golden Mask 5 The Golden Mask 5 is designed to be as simple to operate as possible. The Golden Mask engineers worked hard to simplify the controls and make your hobby a real pleasure, not a search coil bolt struggle with endless functions and menus.
- Page 4 Select the desired value (I or II), the selected option is above the ENTER button, and confirm your choice with the ENTER. RESET FREQUENCY I II GMD - www.goldenmaskdetectors.com - Golden Mask Official Reseller GMD - www.goldenmaskdetectors.com - Golden Mask Official Reseller...
-
Page 5: Disc Mode
As you can guess, select and confirm your choice is done by pressing the + and - buttons and then the ENTER button. In Mono mode, the Golden Mask 5 is a little bit deeper than in bitonal mode and handles better the deep iron signals, if the Discrimination level (DL) is set properly. You will learn about setting the DL level and how it works in the next chapter. -
Page 6: Select Tone
Many people like to always hear the non-ferrous targets and this is not a problem with the Golden Mask 5 even in very polluted areas, because of the fast response of the detector. To work good in areas with lots of iron trash, the DL setting should be set at or near the maximum value of 15 and the sensitivity (PL, power level) should be lowered to 10-15. - Page 7 - on such ground most detectors cannot be ground-balanced or are run- In All metal mode the Golden Mask 5 achieves the best depth of detection, but the differ- ning with strongly reduced performance. The Golden mask 5 is no exception.
- Page 8 If the machine is not balanced, you will hear a sound while the Now start to move the search coil up and down from around 5 to 30 cm (2—12”), this is coil is going up or down. The goal is to change the numbers on the screen (by pressing known as “pumping”...
-
Page 9: Setting The Sound Volume
Setting the power level (PWR) Setting the sound volume The power level setting is the Golden Mask 5 sensitivity. The higher the number, the To set the sound options, press the tone button at the middle of the right column on the deeper the signal goes. -
Page 10: Charging The Batteries
Charging the batteries IRON FOIL NICKEL COPPER SILVER The Golden Mask 5 is delivered with pre-installed 10 x 1500mAh 1.2V AA-size NiMh re- chargeable batteries (this is subject to change, while shipping batteries in some destina- tions is prohibited). The batteries have a life of around 300 cycles charge/discharge. - Page 11 After the charging is complete, the light will turn to blue color. You can now disconnect the charger and start using the detector. The Golden Mask 5 comes in a standard set with a 23 cm (9 inch) dual-frequency Spider Specifications of the smart charger search coil.
- Page 12 Do not use other charger than the supplied with your machine. Third party chargers may be very dangerous for the batteries and may cause fire. Do not forget to turn off your detector after you end searching - this ruins the batteries. Good Luck! GMD - www.goldenmaskdetectors.com - Golden Mask Official Reseller...
Need help?
Do you have a question about the 5 and is the answer not in the manual?
Questions and answers