National Instruments PXI-8150 Series Installation Manual

INSTALLATION GUIDE
PXI-8150 S

What You Need to Get Started

Installation Procedure

Caution:
!
PXI™ is a trademark of National Instruments Corporation. Product and company names are trademarks or trade names of their respective companies.
321762A-01
RAM U
ERIES
This guide describes how to install an additional memory DIMM into the
PXI-8150 Series module.
Use a 144-pin, 60 ns EDO SO-DIMM to upgrade the memory of your
PXI-8150 Series module. You do not need any additional parts or tools.
To prevent electrostatic discharge, touch the antistatic plastic package to
a metal part of your PXI mainframe before removing the DIMM from the
package.
Use the following procedure to install additional RAM in your PXI-8150
Series module:
1. Turn off the mainframe power.
2. Remove the PXI-8150 Series module from the mainframe. To remove
the module, loosen the front panel retaining screws, push down on the
injector/ejector handle, and slide the module out of the mainframe.
3. Insert the DIMM into an open DIMM socket on the module at a 30°
angle, as shown in Figure 1. Push the DIMM down until it latches on
both sides of the socket.
4. Reinstall the PXI-8150 Series module in the mainframe.
The RAM installation is complete.
© Copyright 1997 National Instruments Corp. All rights reserved.
PGRADE
September 1997