System Connection - Dell Networking S4048T-ON Getting Started Manual

• To access EXEC Privilege mode, create a password.
CONFIGURATION mode
enable [password | secret] [level level] [encryption-type]
password
Port-based VLAN creation
The default VLAN, VLAN 1, is part of the system startup configuration and does not require
configuration.
To configure a port-based VLAN, create the VLAN and then add physical interfaces or port
channel (LAG) interfaces to the VLAN.
• Configure a port-based VLAN if the vlan-id is different from the Default VLAN ID.
Enter INTERFACE VLAN mode.
CONFIGURATION mode
interface vlan vlan-id
After you create a VLAN, assign interfaces in Layer 2 mode to the VLAN as needed.
To view the configured VLANs, use the show vlan command in EXEC Privilege mode.

System connection

After you have completed the hardware installation and software configuration for the
system, connect to your company network by following your company's cabling
requirements.
Software configuration 31