Ancona Valencia Series Manual

Single handle pull-out bathroom faucet

Advertisement

Valencia
Single Handle Pull-out Bathroom Faucet
STANDARDS
ASME A112.18.1/CSA B125.1
ASME A112.18.2/CSA B125.2
LISTED IAPMO/cUPC
Flow Rate Chart
Flow diagram
(GPM/min)
3
2
1
0
10
20
30
(Psi)
2019-09-16 MAAN4366-1
GPM/min
40
50
60
70

Helpful Information

Tools:
Gather the necessary tools as shown below to complete the installation of
this faucet. Some may not be needed depending on the model of faucet you
are installing. Check with your local hardware store on the requirements of
your installation situation.
©
®
PLUMBERS PUTTY
SAFETY GLASSES
CHANNELLOCKS
SEALED-TUBE
For easy installation, you will need:
- To read all the installation instructions completely before beginning.
- To read all the warning, attention and maintenance information.
- To purchase the proper supply lines.
A .
Important
C
80
FLASHLIGHT
SCREWDRIVER
ADJUSTABLE WRENCH
HEX-KEY
WARNING:
Please keep the tools for future use!
Connect to water supply lines with either
A 3 8 O D copper tubing ball nose
risers with the coupling nuts or
B .
C .
B 3 8 copper tubing no ball with
supplied tube head interior connector or
C IPS faucet connectors 1 2
Tighten connection with two wrench to prevent damage to
tube body.
Be careful not to bend the stem as this will void the
product warranty
BASIN WRENCH
PLIERS
TAPE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Valencia Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Ancona Valencia Series

  • Page 1 Helpful Information Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Check with your local hardware store on the requirements of Valencia your installation situation.
  • Page 2 Installation size map Faucet Installation 9.8 cm (3.8 in.) Step 2: Secure Spout Body in place: Ø 2 cm (0.8 in.) C. Insert black rubber ring into the metal ring. D. Insert the metal ring in between bottom of Ø 4 cm 16.5 cm faucet body and sink deck hole.
  • Page 3 Cleaning and care Test Faucet Installation A. Move handle into "OFF" position. Daily cleaning and care are required in order to keep the product shining and working properly. B. Turn on water supplies. Check connections for leaks. C. Remove aerator and let both hot and cold water run for 1.

Table of Contents