Advertisement
Deluxe Upper Board: Engineering Guide
DEFAULT AGE
P16 represents the default age, which is displayed in the upper left window. The Treadmill comes with the default age
of 40. You can modify the age by using the
new value.
AUTO-CALIBRATION
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!
Auto-calibration is not represented by a Px designation. " " A A U U T T O O " " appears in the center window. When you enter the
function, " " A A U U T T O O " " begins flashing. To begin auto-calibration, press
maximum speed and maximum incline, this will take three to five minutes. Let the treadmill perform this complete function
before exiting the Engineering Mode.
Elevation A/D or Elevation in % appears in the left window. PWM value or Speed appears in the right window.
" " will appear in the center window when the auto-calibration is complete. When auto-calibration is complete, it
" " E E
will take about 30 seconds to return to the start-up screen with " " P P 1 1 " " showing in the function window.
DISABLE BEEP
P17 represents disable beep. The console has an audible beep that notifies the user when keys are pressed. To turn
off the beep.
SET LANGUAGE
P18 represents the set language function. To change language use the
the desired language. Press and hold
ELEVATION ERRORS
P19 allows you to disable an elevation error. This will allow you to operate the treadmill without elevation.
EXIT USER ENGINEERING MODE
P20 represents exit mode. When you press
to program setup.
** SPECIAL NOTE
When treadmill is first set-up, auto-calibration can be bypassed by pressing
This will take the console to the start-up screen.
TREADMILL.ENG.TM356.REV2
or
"SPEED"
"ELEVATION"
"START"
to save the change.
"ENTER"
to select the function, the console performs a reboot, returning
"ENTER"
39
arrows. Press and hold
"ENTER"
. The treadmill will run through minimum and
and
"SPEED"
"ELEVATION"
-
-
-
.
STOP
5
9
3
Date of last revision: 10.08
to save the
arrows to select
Advertisement
