Cloning One Omega To Another - Universal Remote Control omega MX-650 Owner's Manual

Erasing the Entire Omega
To erase EVERYTHING, press and hold both the MAIN and the STOP
buttons for 15 seconds. After 15 seconds, the RESET screen appears.
Press the SURE button to erase all of your settings and return to the fac-
tory default setup.
ALL Button
erases all
settings.

Cloning One Omega to Another

If you own two or more Omega, you can copy and transfer all the setup
from one Omega to another. Just follow these easy steps:
Enter SETUP mode by pressing and holding both MAIN and ENT
1
for three seconds.
Note: You have 30 seconds for each step, otherwise the Omega will time
out automatically.
2
Press the CLONE button.
3
Align the two Omega head-to-head, about an inch apart.
Press the RECV display button on the new Omega you would like
4
to setup by cloning.
5
Press the SEND display button on the Omega you previously setup.
Press the START button on the new Omega and then press the
6
START button on the Omega you previously setup.
Note: Cloning typically takes about 40 seconds.
After completion, the cloned Omega will flash "GOOD".
7
Return to normal operation by pressing the MAIN button twice.
T h e O m e g a
26
PROG Button
erases three digit
codes, Page, Text
and Punch
Through settings.