Erasing All Learned Commands From; One Component - Universal Remote Control AVEX R6 - SPECS SHEET Owner's Manual

Erasing All Learned Commands from

One Component

This function allows you to erase all the learned
commands from one component. For example, if you
want to erase all learned commands on the TV
component button because you bought a new TV, the
process is very simple.
STEP 1: Press the component button where all the
learned commands are stored and the ENTER button
at the same time for 2 seconds until the component
LED turns on.
IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If you
do not press a button within 30 seconds, the
component LED light will turn off. The remote will exit
the programming mode and you will have to start
over.
STEP 2: Press and hold both the component button
you want to erase and the PAUSE button at the same
time for two seconds, until the component LED light
blinks twice to confirm the erasure.
COMPONENT
BUTTONS
PAUSE
ENTER
STEP 3: To exit Erase mode, press and hold both the
component button and the ENTER (ENT) button at the
same time until the component LED light blinks three
times.
Page 26