Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7409-K566
Summary of Contents for NCR 7409-K566
- Page 1 7409‐K566 Swivel Mount Bracket Kit Instructions Issue A ...
-
Page 2: Revision Record
Revision Record Issue Date Remarks A Aug 2010 First issue ... -
Page 3: Kit Contents
7409-K566 Introduction This kit contains a swivel mount for a terminal mounted on a Fixed Angle Mount (7409‐K035). When installed on a check stand the device can be rotated up to 340 degrees. The sections that follow describe how to install the Swivel Mount Bracket in a check stand how to install a Fixed‐Angle Mount on the Swivel Mount Bracket. Kit Contents Rear Cover Fixed Angle Mount (7409-K035) 497-0468273 (for Reference Only) Screw, 8-32 x 0.25, Phillips, Truss Hd 006-8616058 7402 Locking Swivel Mount 497-0443897 Screw, Socket Cap, 1/4-20 x 2", Flat Hd 006-8608261 Screw, 6-32 x 0.25... -
Page 4: Mount Dimensions
7409-K566 Mount Dimensions 134 mm (5.28 in.) 72 mm Rests on (2.83 in.) Checkstand Surface 18468 ... - Page 5 7409-K566 Installing the Swivel Mount Bracket 1. In the desired location, drill an 88.9 mm (3.5ʺ) hole in the top of the checkstand for the Swivel Mount Bracket. 88.9 mm (3.5 in.) 7 mm x4 18465 (.277 in.) 2. Place the Swivel Mount Bracket into the hole. ...
- Page 6 7409-K566 3. As shown in the following illustration, the maximum rotation is 340 degrees. Making sure that the terminal can rotate to the desired positions, mark the checkstand through the four screw holes in the flange. Note: The maximum rotation is 340 degrees. This leaves a 20 degree ʺDead Zoneʺ through which the swivel cannot rotate and the display cannot be viewed directly. The center of the ʺDead Zoneʺ is always 90 degrees from the tab in the flange. Keep this in mind when planning the installation and marking the checkstand through the four screw holes. Tabs for securing Fixed-Angle Mount Maximum rotation is 340 degrees Display faces this side Dead Zone Flange (20 Degrees) 18499 4. Remove the Swivel Mount Bracket and drill four 7 mm (.277ʺ) holes in the marked locations. 5. Place the Swivel Mount Bracket into the hole in the checkstand. ...
- Page 7 7409-K566 6. Use the Retaining Ring and the four Mounting Screws to secure the Swivel Mount Bracket to the checkstand. Checkstand Retaining Ring Mounting Screws (4) 18498 ...
- Page 8 7409-K566 Installing a Fixed-Angle Mount on the Swivel Mount Bracket 1. Align the slots in the bottom of the Fixed‐Angle Mount with the Locking Tabs on the Swivel Mount Bracket. Lock the Fixed‐Angle Mount in place by sliding it toward the rear of the Swivel Mount Bracket. Fixed-Angle Mount Locking Tabs Securing Screws 18496 ...
- Page 9 7409-K566 2. Use the two Securing Screws to secure the Fixed‐Angle Mount to the Swivel Mount Bracket. 3. Insert the two tabs on the Cover into the two lower slots on the back of the Fixed‐Angle Mount. Cover 17744 4. From inside the Fixed‐Angle Mount, secure the Cover with screws and washers (2). ...