Table of Contents
Advertisement
Steps
1. Lay the computer on the right side.
2. Disconnect the data and power cables from the hard drive.
3. Press the release tabs on the hard-drive carrier and slide the hard-drive carrier out of the hard-drive cage.
4. Pry the hard-drive carrier to release the tabs on the carrier from the slots on the hard drive.
5. Lift the hard drive off the hard-drive carrier.
NOTE:
Note the orientation of the hard drive so that you can replace it correctly.
Installing the 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
The computer ships with two empty 2.5-inch hard-drive cages. A 2.5-inch hard drive (sold separately) is
required to perform below procedures.
22
Removing and installing components
Hide quick links:
Advertisement
Table of Contents
